| Гость | Дата: Пятница, 16.09.2011, 11:13 | Сообщение # 26 |
|
Группа: Посетители
| Me too, Bob. Lost in the middle somewhere that is. Been following this one with great interest but I think I'll go back to doing what I know how to do and wait until you guys get it figured out and let me know how.
|
| |
| |
| Гость | Дата: Пятница, 16.09.2011, 11:13 | Сообщение # 27 |
|
Группа: Посетители
| I took the files that arno sent me through email:
kmemexcl.bgl and test.sca
I dropped test.sca onto scasm.exe and it created one bgl file called test.bgl. Comparing this to the file he sent me, kmemexcl.bgl I noticed the files were no where close to being similar (my above post).
I then went to a command window and typed scasm.exe test.bgl and it produced two bgl files. test.bgl I deleted because of instruction given by arno. kmemexcl.bgl (the other bgl this process created) was identical to the kmemexcl.bgl arno sent me through email. I then changed the lat/long in test.sca to a smaller area and compiled it with the command prompt command again and once again, it created two bgl files, so I tossed test.bgl into the recycle bin again.
After opening fs2k2 with only kmemexcl.bgl in the folder all worked as it should, with the exception that I was unable to delete the tarmac and taxiways. I continued increasing the size of the box in test.sca until it excluded everything in the airport again (which is not what I wanted to have done) so apparently the reference points for the tarmac are located close to or in the same place as the reference points for the entire airport?
Hope that explains it ...
|
| |
| |
